200 Oser Ave.
Hauppauge, NY 11788 US
- Visit Company Website
A Message from Royal Products
As Seen In Production Machining
Ultimate Multitasking Live Center Helps Extend Operating Life
The live center is designed to be extremely accurate, with runout guaranteed to ±0.0001" TIR or better.
Increase Throughput with Off-the-Shelf Automation
This automated parts accumulator is designed to complement any bar-fed CNC lathe, providing hours of profitable, unattended operation by safely collecting and organizing finished parts.
Video: Parts Accumulator Allows for Unattended Machining
One of the advantages of a Swiss-type lathe is that once you’ve set up the bar feeder, you’re good to go until you run out of barstock. This accumulator simplifies the other end of the operation.
Royal Products’ Quick-Grip CNC Collet Chucks Reduce Change-Overs to 10 Seconds
These collet chucks enable operators and manufacturers to improve their production times and accuracy while eliminating change-over problems associated with standard collets.
Royal Products Hires New Regional Manager
Matt Block will support Royal's distribution network throughout Wisconsin, Illinois, Northeastern Missouri, Iowa, and Nebraska.
Collet Chuck Essentials
“Understanding CNC Collet Chucks” has been one of the most read articles in our archives during the past several years and continues to get substantial traffic today.
Chuck Stop Locates Short Parts in a Three-jaw Lathe Chuck
Royal Products’ chuck stop provides a simple method for locating short parts in a three-jaw lathe chuck.
Chuck Stop Provides a Simple Method for Locating Short Parts
The Royal Products’ chuck stop provides a simple method for locating short parts in a three-jaw lathe chuck.
Precision CNC Milling Chuck Maximizes Tool Performance
Albrecht’s Überchuck power milling chucks maximize machine tool performance throughincreased tool life, throughput and profitability, the company says.
Live Centers, Collet Chucks and More
Royal Products will present a suite of five Standard Special live centers at IMTS 2012.
Improve the Shopfloor Environment
Any form of pollution in the shop environment is potentially dangerous to personnel.
High Precision CNC Quad Bearing Live Centers
The high precision CNC quad bearing live center is especially useful for grinders, CNC turning centers and manual lathes.
Mist and Smoke Collectors for Metalworking Applications
While many companies are aware of the traditional problems associated with oil mist, few are aware that failure to adequately address mist and smoke issues often results in reduced productivity and increased machine downtime.
Collet Chucks with Special Installation
Quick-Grip CNC collet chucks from Royal Products offer a number of advantages over traditional collet chuck designs, the company says.
The Many Sides of Workholding
Here's a broad look at different ways to approach workholding based upon the requirements of the application.
Parts Collector for Lights-Out Machining
The Rota-Rack is a device that enables any bar-fed CNC lathe to run unattended for extended periods of time.
Understanding CNC Collet Chucks
Workholding for turning is usually fairly basic: The selection comes down to chucks or collets. This article looks at when to consider the collet chuck and what kind might be best for a given application.
CNC Bar Pullers
CNC bar pullers can provide an inexpensive means of automating any CNC lathe.
Rotary Parts Accumulator
This rotary collection device allows safe parts accumulation from untended bar-fed lathes. It is programmed to index with each part produced, collecting parts without allowing them to collide with one another.
The Rota-Rack Parts Accumulator is a lean, cost-effective device that enables any bar-fed CNC lathe to run untended for extended periods of time. The unit indexes each time a finished part exits the machine, collecting and protecting finished workpieces.