9/30/2004

Washer Inspection System

Facebook Share Icon LinkedIn Share Icon Twitter Share Icon Share by EMail icon Print Icon

The new G-100 washer inspection system uses multiple inspection technologies including lasers for flatness inspection, vision for hole diameter, as well as concentricity inspection and eddy current for heat treat and plating thickness verification. The system inspects and sorts large varieties of washers at rates exceeding 300 ppm. It can reduce part-per million (ppm) defects encountered in the high-volume stamping, screw machining and cold heading industries.

Share

Facebook Share Icon LinkedIn Share Icon Twitter Share Icon Share by EMail icon Print Icon

Related Suppliers

The new G-100 washer inspection system uses multiple inspection technologies including lasers for flatness inspection, vision for hole diameter, as well as concentricity inspection and eddy current for heat treat and plating thickness verification. The system inspects and sorts large varieties of washers at rates exceeding 300 ppm. It can reduce part-per million (ppm) defects encountered in the high-volume stamping, screw machining and cold heading industries.

Hand holding a crystal ball

We’d rather send you $15 than rely on our crystal ball…

It’s Capital Spending Survey season and the manufacturing industry is counting on you to participate! Odds are that you received our 5-minute Metalworking survey from Production Machining in your mail or email. Fill it out and we’ll email you $15 to exchange for your choice of gift card or charitable donation. Are you in the U.S. and not sure you received the survey? Contact us to access it.

Help us inform the industry and everybody benefits.

RELATED CONTENT

  • Keeping Watch on Small Parts

    From watch parts to exotic medical applications, this shop takes on the world of micromachining.

  • To Scan or Not to Scan

    Industrial metrology professionals are constantly tasked with finding the best methodology to inspect parts.

  • Determine Passivation of Stainless

    Properly cleaned stainless steel is naturally protected from corrosion by a thin, passive film. But this passive layer can be removed or scratched. A passivation meter measures the surface potential under controlled conditions.

Resources